To Next Page

To Previous Page

CONTROL PANEL

Operating Instructions

To set temperature for smoking:

• Press ON/OFF button . LED will display temperature/meat probe/time in sequence.

• Press the SET TEMP button once. LED will display boTM (bottom element).

• Press the SET TEMP button again to select the bottom element.

• Press the UP or DOWN arrows to select temperature. The maximum temperature setting is 275°F

(135°C).

• Press the SET TEMP button again to lock in the temperature.

• The bottom element icon will illuminate to indicate temperature has been set.

To set timer:

• Countdown Timer:

• Press the SET TIME button once-LED display for hours will blink.

• Use the UP or DOWN arrows to set hours.

• Press the SET TIME button again to lock in hours. The minutes LED will start blinking.

• Use the UP or DOWN arrows to set minutes.

• Press the SET TIME button to lock in minutes and start the timer.

• Duration (Count-up) Timer:

• This timer will start counting from 00:00.

• Press and hold the SET TIME button once - LED display will start counting from 00:00.

NOTE: When outside temperature is cooler than 65°F (18°C) and/or altitude is above 3,500 feet (1067m),

additional cooking time may be required. To ensure that meat is completely cooked use a meat

thermometer to test internal temperature or use meat probe, if featured.

Grill + Finish Element:

• The Grill + Finish element provides two unique beneﬁts:

1. Food can be slow-smoked and then positioned under the top broiler element to crisp or carmelize a

sauce.

2. Food can be cooked under the Grill + Finish element quicker than traditional smoking, similar to a

broiler in an oven.

Setting the Grill + Finish element:

• Press the SET TEMP button once. LED will display boTM (bottom element).

• Press the UP or DOWN arrows to select ToP (Grill + Finish element) and press SET TEMP again.

• Press the UP or DOWN arrows to select High/Medium/Low.

• Press the SET TEMP button again to lock in the setting.

• The Grill + Finish element icon will illuminate to indicate temperature has been set.

NOTE: A time does not have to be set. The element will begin heating once the temperature is set.

Masterbuilt MB25073519 User Manual

Questions and Answers: