21
HOW TO USE CONTROL PANEL & REMOTE CONTROL
Note: Direct sunlight may interfere with ability to read LED display, block light if needed.
To set temperature:
• Press ON/OFF button.
• Press SET TEMP button once-LED display will blink.
• Use up or down arrows to set temperature.
• Press SET TEMP button again to lock in temperature.
Note: Heating will not begin until timer is set.
To set timer:
• Press SET TIME button once-LED display for hours will blink.
• Use up or down arrows to set hours.
• Press SET TIME button again to lock in hours. The minutes LED will start blinking.
• Use up or down arrows to set minutes.
• Press SET TIME to lock in minutes and start cook cycle.
Heat will turn o when time has expired.
To use meat probe (If featured):
• Insert meat probe into center of meat to get most accurate reading.
• Press and hold MEAT PROBE button-LED display will show internal temperature of meat.
• Once MEAT PROBE button is released-LED display will return to set temperature or set time.
To use light (If featured):
• Press LIGHT button to turn light on.
• Press LIGHT button to turn light o.
To RESET control panel:
If control panel shows an error message, turn electric smoker o, unplug unit from outlet, wait
ten seconds, plug unit back into outlet, then turn electric smoker on. This will reset control panel.
Actual product may dier from picture shown.
(If featured)
®
To Next Page
Loading...
Need help?
General
