ANGLE GRINDER - 054-7120-4
13
Adjust the guard (fig 3)
WARNING!
Failure to unplug the tool from the power
source when assembling parts, making
adjustments, or changing application
tools could result in accidental starting
and cause serious injury.
1. Unplug the angle grinder.
2. Press the guard-adjusting lever, and hold it to
loosen the guard.
3. Rotate the guard to the desired position and make sure the lever lines up with notches on the
guard.
4. Release the guard-adjusting lever to lock the guard and make sure the lever secures the guard.
WARNING!
Never use your grinder with the guard removed. It has been designed for use only with the
guard attached. Attempting to use the grinder with the guard removed will result in loose
particles being thrown against the operator and possibly serious personal injury.
WARNING!
Only use the guard with grinding wheels. Make sure that the guard-adjusting lever secures
the guard before plugging in. Keep the guard between you and wheel. Do not direct the
guard opening towards your body.
OPERATING INSTRUCTIONS
fig 3
Notch on the guard
Guard-
adjusting lever