EasyManuals Logo

MasterCraft 054-7120-4 User Manual

MasterCraft 054-7120-4
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
ANGLE GRINDER - 054-7120-4
8
Never lay the power tool down until the accessory has come to a complete stop. The
spinning accessory may grab the surface and pull the power tool out of your control.
Do not run the power tool while carrying it at your side. Accidental contact with the spinning
accessory could snag your clothing, pulling the accessory into your body.
Regularly clean the power tool’s air vents. The motor’s fan will draw the dust inside the housing
and excessive accumulation of powdered metal may cause electrical hazards.
Do not operate the power tool near flammable materials. Sparks could ignite these materials.
Do not use accessories that require liquid coolants. Using water or other liquid coolants may
result in electrocution or shock.
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
............... Alternating current
............. Direct current
n
0
................... No-load speed
............... Class II Construction
…/min ........... Revolutions per minute
............... Grounding terminal
BPM ............... Beats per minute
.............. WARNING – To reduce the risk of injury, user must read instruction manual.
Further safety instructions for operation
Kickback and Related Warnings
Maintain a firm grip on the power tool and position your body and arm to allow you to
resist kickback forces. Always use an auxiliary handle, if provided, for maximum control
over kickback or torque reaction during start-up. The operator can control torque reactions or
kickback forces, if proper precautions are taken.
SAFETY GUIDELINES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft 054-7120-4 and is the answer not in the manual?

MasterCraft 054-7120-4 Specifications

General IconGeneral
BrandMasterCraft
Model054-7120-4
CategoryGrinder
LanguageEnglish

Related product manuals