A
B
D
A
• Place the table saw on top of the stand, aliging
the holes in the base with the holes in the
stand.
• Insert four hex bolts M6 x 25 (1) along with big
flat washers 6 (2) into the aligned holes. Tighten
with hex nuts M6 (3).
see page 33
1
• The product can be switched on by
pressing the green “I”-Button on the
on/off switch (1).
• The product can be switched off by
pressing the red “0”-Button on the
on/off switch (1).
see page 50
2
SPECIFICATIONS
Motor
Speed
Blade
Arbour size
Main table size
Extension table size
Table height
Depth of cut at 90°
Depth of cut at 45°
Rip capacity
Bevel range
Mitre range
Weight
120 V AC, 60 Hz, 15A
4700/MIN (no load)
10" (25.4 cm) 24-tooth carbide-tipped
5/8" (1.59 cm)
23 5/8 x21 3/16" (60 x 53.8 cm)
5 1/2 x 21 3/16" (14 x 53.8 cm)
35" (89 cm)
3 9/64" (80 mm)
2 5/32" (55 mm)
13" (33 cm) right; 10" (25.4 cm) left
0-45°
0-60° right & left
56 lb 6 oz (25.6 kg)
5
SPECIFICATIONS
4
QUICK START GUIDE
model no. 055-6755-8 | contact us 1-800-689-9928
1
1
3
2
To Next Page
Loading...
