ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
MOUNTING THE PARALLEL CUTTING GUIDE (Fig. 11)
• Attach the rear end of the parallel cutting guide (1) to the rear of the working table.
• Push the spring (2), clamp (3) and flat washer (4) onto thread (5).
• Screw locking knob (6) onto thread (5) and turn it clockwise to tighten securely.
ADJUSTING THE PARALLEL CUTTING GUIDE
• Gently turn locking knob on parallel cutting guide counter-clockwise to loosen.
• Use parallel cutting guide scale, located on front and rear of working table, to set parallel cutting guide to
desired width of cut.
• Turn locking knob clockwise to tighten securely.
2120
INSTALLING THE MITRE CUTTING GUIDE (Fig. 12)
• Slide mitre cutting guide (1) onto parallel cutting
guide (2) from front.
• Adjust parallel cutting guide to desired position and
secure.
• Adjust to desired angle using angle scale (3) and tighten
securely with locking knob (4).
INSTALLING THE WATER RESERVOIR PLUG (Fig. 13)
• Raise the 45° vertical fence approx. 45° and remove.
• Locate hole on bottom of water fill reservoir.
• Push water reservoir plug (1) into hole firmly.
• Replace 45° vertical fence.
Fig. 12
Fig. 13
Fig. 11
NOTE:
The mitre cutting guide can be set to a desired angle (0°-45°). The mitre cutting guide can only be used
when the parallel cutting guide is mounted.
model no. 055-6778-4 | contact us 1-800-689-9928
1
25 3 4 6
2
3 1
4
1
To Next Page
Loading...
