MasterCraft 055-6778-4 - Quick Start Guide

• Gently turn locking knob (2) on parallel
cutting guide counter-clockwise to loosen.
• Adjust the parallel cutting guide in the
desired position using the parallel cutting
guide scale (3), located on front and rear
of table, to set parallel cutting guide to
desired width of cut.
• Turn locking knob clockwise to tighten
securely.
see page 24
• Locate hole on bottom of water fill
reservoir.
• Push water reservoir plug (1) into hole
firmly.
see page 21
1
model no. 055-6778-4 | contact us 1-800-689-9928
SPECIFICATIONS
Motor
Speed
Table tilts
Blade
Table size
Max. cutting thickness
Weight
120V, 60 Hz, 5.0A
5300 RPM (no load)
0°,15°, 30° & 45°
7" (17.8 cm) diamond-tipped
13 9/16 x 13 9/16" (34.5 x 34.5 cm)
1 3/16" (30 mm) at 90°; 15/32" (12 mm) at 45°
16 lb 8 oz (7.5 kg)
5
SPECIFICATIONS
4
QUICK START GUIDE
2
1
3
3
4
1 65 2