Installation
1. Ensure disc-plate is clean.
2. Peel backing from new sanding disc.
3. Press new sanding disc rmly onto disc-plate.
Note: Hook & Loop sanding discs cannot be used with this type of sander!
Replace the sanding table and handles that were removed in step 2 (above).
Dust Chute/Port – Operation
Sanding operations are inherently dusty. To help minimize the amount of dust that escapes into the
surrounding air, this Mastercraft sander is equipped with a 2 1/4” (57 mm) dust chute (aka: port) that
can be easily connected to a dust-collection system. It is strongly recommended that users employ a
dust-collection system when using this belt & disc sander.
Use of a mask or respirator is still recommended even when a dust-collection system is in use.
13
To Next Page
Loading...
