MAINTENANCE
28
MIG/FLUX-CORE WIRE FEED WELDER KIT 058-8195-2
Maintenance
The welder needs regular maintenance as following:
• Clean the dust, dirt, and grease periodically from the welder.
• Every six months, remove the front panel from the welder to clear the accumulated dust and
dirt.
• Replace power cord, ground cable, ground clamp, or electrode assembly when damaged or
worn.
• Repairs must be performed by a qualified service technician only.
Storage
• Store the welder in a clean and dry location away from corrosive gas and excess dust at a
temperature of 10°F
-120°F and relative humidity of less than 90%.
• It is recommended to repack the welder when transporting or storing the welder after use.
• Cleaning is required before storage.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Unplug the welder before performing any maintenance or service.
• Only use the welder after replacing or repairing any damaged parts or
accessories.
• Use only recommended and properly rated replacement parts. Failure to
comply could lead to serious injury or loss of life.
MAINTENANCE
REQUIRED
DESCRIPTION
TOOLS OR
MATERIALS
REQUIRED
MAXIMUM SERVICE INTERVAL
Each Use or
every 2 Hrs
Monthly
As
Needed
In-depth inspection
Worn or broken
parts
X X
Replace worn or
broken parts
X
To Next Page
Loading...
Need help?
General
