Name: MasterCraft FLUX-CORE
Brand: MasterCraft
Rating: 5 (1 reviews)

To Next Page

To Previous Page

TROUBLESHOOTING

MIG/FLUX-CORE WIRE FEED WELDER KIT 058-8195-2

Note: For further repair information, please call 1-800-689-9928.

Inconsistent arc or

wire feed.

1. Not enough drive roller pressure.

2. Spool hub tension too tight or

loose.

3. Contact tip worn or wrong size.

4. Rusty or corroded wire.

1. Tighten the drive tension adjustor on wire

feeder.

2. Adjust the wing nut on the spool holder.

3. Replace the contact tip.

4. Replace the wire.

PROBLEM POSSIBLE CAUSES SOLUTIONS

Questions and Answers:

Need help?

Do you have a question about the MasterCraft FLUX-CORE and is the answer not in the manual?

MasterCraft FLUX-CORE Specifications

General