SAFETY EQUIPMENT FOR ANGLE GRINDER
ATTACHMENT
Your angle grinder attachment is a high speed tool
that will throw hot sparks and metal dust when
grinding. It will also throw particles and dust when
sanding. It is critical that you use proper safety
goggles, dust mask and hearing protection at all times
while operating this tool.
PLACEMENT OF GUARD
Guard must always be rotated toward the rear of the
unit so it protects your hand on the side handle and
also to prevent dust from entering the motor as you
operate the tool.
To reposition the guard, simply rotate it to the correct
position.
OPERATION OF ANGLE GRINDER ATTACHMENT
1. Install appropriate grinding disc or sanding disc.
NOTE: Check to make sure grinding disc or sanding
disc is not cracked or damaged in any way.
2. Firmly grasp Spin Saw with both hands and turn
switch ON. Make sure grinding disc or sanding disc is
NOT touching the workpiece when turning switch ON.
3. Wait until motor reaches full speed before grinding or
sanding.
4. Carefully allow front or right hand side of the disc to
contact the workpiece in the area to be worked.
NOTES:
a) Do NOT apply heavy pressure to the grinding disc or
sanding disc. This will slow the motor down causing it to
overheat and possibly damage the motor.
b) Replace damaged or worn grinding discs and sanding
discs. The new abrasive will cut much faster and leave a
smoother finish.
To Next Page
Loading...
Need help?
General
