MAINTENANCE
42
MIG 180 INVERTER WELDER 058-9306-4
Maintenance
The welder needs regular maintenance as following:
• Clean the dust, dirt, and grease periodically from the welder.
• Every six months, remove the front panel from the welder to clear the accumulated dust and
dirt.
• Replace power cord, ground cable, ground clamp or electrode assembly when damaged or
worn.
• Repairs must be performed by a qualified service technician only.
Storage
• Store the welder in a clean and dry location away from corrosive gas and excess dust at a
temperature of -12°C-48°C (10°F-120°F) and relative humidity of less than 90%.
• It is recommended to repack the welder when transporting or storing the welder after use.
• Cleaning is required before storage.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Unplug the welder before performing any maintenance or service.
• Only use the welder after replacing or repairing any damaged parts or
accessories.
• Use only recommended and properly rated replacement parts. Failure to
comply could lead to serious injury or loss of life.
MAINTENANCE
REQUIRED
DESCRIPTION
MAXIMUM SERVICE INTERVAL
Monthly As Needed
In-depth inspection Worn or broken parts X X
Repair or replacement Worn or broken parts X
To Next Page
Loading...
