TROUBLESHOOTING
44
MIG 180 INVERTER WELDER 058-9306-4
Note: For further assistance on installation and repairs, please contact 1-800-689-9928.
Inconsistent arc or
wire feed.
1. Not enough drive roll pressure.
2. Spool hub tension too tight or
loose.
3. Contact tip worn or wrong size.
4. Rusty or corroded wire.
5. Electrode or damaged flux is too
big.
1. Tighten the drive tension adjustor on wire
feeder.
2. Adjust the wing nut on the spool holder.
3. Replace the contact tip.
4. Replace the wire.
5. Use correct or undamaged electrode.
PROBLEM POSSIBLE CAUSES SOLUTIONS
To Next Page
Loading...
