Page 14
BLOWER OPERATION
This Wet/Dry Vacuum has blowing capabilities.
To use the blower feature, follow the instructions
listed.
WARNING:
ALWAYS WEAR SAFETY
GOGGLES COMPLYING WITH ANSI Z87.1
(OR IN CANADA, CSAZ94.3) BEFORE USING
BLOWER.
CAUTION:
KEEP BYSTANDERS
CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF
BLOWING CREATES DUST THAT MIGHT BE
INHALED.
1. Verify that the power cord is disconnected
from the outlet (Fig. 1).
Fig. 1
2. Make sure the collection tank is empty before
using as a blower. Clear all dirt and debris
from the hose and collection tank.
3. Remove the hose from the vacuum port.
Remove noise diffuser from blower port.
4. Insert the larger end of the hose into the
blower port on the back side of the power
head and lock into place (Fig. 2).
Fig. 2
5. Choose the desired accessory and insert
onto the end of the hose (Fig. 3).
Fig. 3
6. Verify that the on/off switch is in the ‘O’ OFF
position before plugging the power cord
into the outlet. Plug the power cord into the
outlet (Fig. 4 & 5).
Fig. 4
Fig. 5
7. Before turning on the vacuum, firmly hold the
loose end of the hose. Turn the motor on
by flipping the switch to the ‘I’ ON position
(Fig. 6).
To Next Page
Loading...
