MasterForce 240-5417 - Installing & Cleaning Foam Wet Filter; Installing the Foam Wet Filter; Cleaning the Foam Wet Filter

Page 19
DUST BAG INSTALLATION INSTRUCTIONS
1. Lift the power head off the collection tank
(Fig 1).
2. Slide the cardboard dust bag flange onto
inlet port until it stops (Fig 2).
3. Unfold the dust bag so that it is evenly
distributed around the inside of the tank
(Fig 3).
4. Place the power head back on the
collection tank and secure into place using
latches (Fig 4).
Fig. 1
Fig. 2
Fig. 3
Fig. 4