MasterForce 270-3282 - Maintenance

Page 13
OPERATION TIPS
If it is possible, clear the snow with the
direction of the wind.
• In strong winds, lower the chute deector to
direct the snow to the ground.
• When you complete the work, let the
machine operate for a while to prevent ice
formation in the discharge chute.
• If the snow is deeper than 8", decrease the
speed and let the machine work at its own
rhythm.
• Do not use the machine to remove compact
snow and ice.
WARNING
Remove the
safety key and battery pack from the
machine before maintenance.
WARNING
Wear correct
clothing, gloves and safety glasses
before maintenance.
CAUTION
Use only
approved replacement parts.
CAUTION
Do not let brake
uids, gasoline, petroleum-based
materials touch the plastic parts.
Chemicals can cause damage to
the plastic, and make the plastic
unserviceable.
CAUTION
Do not use
strong solvents or detergents on the
plastic housing or components.
GENERAL MAINTENANCE
• Before each use, examine the machine for
damaged, missing, or loose parts such as
screws, nuts, bolts and caps.
• Tighten correctly all the fasteners and
caps.
• Clean the remaining snow on the machine
with a brush.
REPLACE THE SCRAPER
WARNING
Use only
approved replacement scrapers.
WARNING
Wear heavy
gloves or wind cloth around the impeller
when you touch the impeller.
WARNING
The scraper is
located at the bottom of the impeller
housing. Ensure that the battery is not
installed in the tool.
1. Turn the machine to its side.
2. Remove the 5 bolts below the deck that
attach the scraper to the machine.
3. Remove the worn scraper from the
machine.
4. Install the new scraper.
5. Install and tighten the bolts that you
removed.
OPERATION
MAINTENANCE
Bolt
FIG. 12
Scraper