INSTALLING NEW MOTOR BRUSHES
13. Once the old carbon brush has been
removed, use a SOFT DRY brush to
carefully remove all grinding dust from the
brush holder and install the new carbon
brush in the reverse order that was used to
remove the worn carbon brush.
14. Reinstall the new carbon brush in reverse
order of paragraphs 10, 11 & 12.
NOTES:
a) Make sure the braided brush wire is routed
EXACTLY the same as the original.
b) Make sure the end of the coil spring is
placed on top of the carbon brush (Fig. 10).
15. Turn the tool onto its face to remove and
replace the second carbon motor brush
using the same procedures noted above.
16. Once both carbon brushes have been
replaced, reposition the left half of the
handle, place the lock-on button & spring
assembly and switch lever where they
were removed.
17. Replace the right hand half of the handle,
making sure it fits properly and that all six
screws are fully tightened in place.
To Next Page
Loading...
