10
Fence Assembly Instructions cont.
Place completed fence bracket on table so holes line up with table slits. There are 2 remaining lengths of carriage
bolts (one medium and one long). Use the medium one on hole #1 and long one on hole #2. See completed.
4
#1
#2
#1
#2
Insert pin into chip guard and fence
bracket as shown.
5
OPTIONAL: Use holes on the bottom of table legs to mount table to
a surface or to power tool stand. Fasteners not included.
6
Completed router table should
look like this. You are now ready
to install your router.
7
To Next Page
Loading...