To Next PageTo Next Page
Need help?Do you have a question about the Mastervolt CHARGEMASTER 12/35-3 and is the answer not in the manual?
General| Input Voltage | 90 - 265 VAC |
|---|---|
| Input Frequency | 50/60 Hz |
| Output Voltage | 12 V |
| Output Current | 35 A |
| Number of Outputs | 3 |
| Efficiency | > 90% |
| IP Rating | IP22 |
| DC Connection | Screw terminals |
| Protection | Over temperature, short circuit, reverse polarity |
| Temperature Range (ambient) | -20°C to +50°C |
| Humidity | 0 to 95% (non-condensing) |
| Battery Types | Lead-acid, AGM, Lithium |
| Cooling | Convection cooled |
General safety rules and precautions for operating the Chargemaster.
Warnings about risks of explosive gases near lead-acid batteries and precautions.
Safety advice for working with lead-acid batteries, including personal protection and handling.
Instructions on how to activate the charger and switch it to stand-by mode.
Details the BULK, ABSORPTION, and FLOAT phases of the charging process.
Describes how the unit is protected against faults and how failures are indicated.
Covers essential aspects of AC and DC wiring, including cable sizes and connections.
Provides specifications for AC wiring, including cross-section and wire colours.
Details DC wiring requirements, including cable cross-sections for different models.
Explains the importance of AC safety grounding and connecting the ground terminal.
Provides warnings and notes regarding the connection process of the Chargemaster.
Steps and considerations for commissioning the Chargemaster after installation.
Details the four DIP switches and their functions for configuring the Chargemaster.
Warnings and instructions for using the equalize mode with DIP switch 4.
Overview of monitoring and programming capabilities via MasterBus.
Parameters that can be configured via the MasterBus network or MasterAdjust software.
A table listing common malfunctions, their possible causes, and troubleshooting steps.
