To Next PageTo Next Page
Need help?Do you have a question about the Mastervolt CHARGEMASTER 12/50-3 and is the answer not in the manual?
General| Input Voltage | 90-265 V AC |
|---|---|
| Input Frequency | 45-65 Hz |
| Output Voltage | 12 V |
| Output Current | 50 A |
| Number of Outputs | 3 |
| Charging Stages | 3 |
| Protection | Short circuit, Overload, Overtemperature |
| Cooling | Fan |
| Operating Temperature | -20°C to +50°C |
Provides essential safety and operating instructions for the Chargemaster in various applications.
Highlights dangers associated with explosive gases from batteries and precautions.
Specific safety advice for handling and charging lead-acid batteries to prevent hazards.
Describes the main features and capabilities of the fully automatic battery charger.
Instructions for activating the charger and placing it into stand-by mode.
Details the Bulk, Absorption, and Float stages of the three-step Plus charging method.
Information on fault conditions, protected circuits, and failure indicators.
General guidance on wiring practices and battery types suitable for connection.
Details on selecting the correct cross-section for AC wiring based on current.
Recommendations for DC cable cross-sections and connection polarity for battery banks.
General warnings and precautions before connecting AC and DC wiring.
Configuration setting for selecting the type of battery connected (Wet, Gel/AGM).
Setting for choosing the charging algorithm: IUoUo or Constant Voltage.
Instructions and rules for connecting devices and configuring the MasterBus network.
Guide to monitoring and programming the Chargemaster via the MasterBus network.
Parameters that can be adjusted for the Chargemaster via the MasterBus network.
A comprehensive table listing malfunctions, possible causes, and recommended solutions.
