Mass Combi Ultra 12/3000-150, 24/3500-100, 48/3500-50 – User and Installation Manual
4.3.3 Secondary charging policy
Secondary battery charging takes place when:
activated by the Force sec charge event (section 6.2.3);
charging from AC input;
set to a constant voltage (section 6.1, 6.2).
4.4 Maintenance
Checking all connections every 6 months is required.
Further, no specific maintenance is required. If necessary,
use a soft clean cloth to clean the Mass Combi Ultra. Do
not use any liquids or corrosive substances, such as
solvents, alcohol, petrol or abrasive components.
4.5 Daily use, MasterBus monitoring
Below table shows the MasterBus Monitoring page. On this
page you can adjust the daily settings.
The state of your Mass
Combi Ultra
Standby; Inverting; Alarm; Charging; Supporting;
Overload; Low battery
Option to switch Off the
inverter to prevent depleting
of your batteries.
Initializing; On; Standby; Inverter off; Charger off
No AC present, Generator, Mains, Poor quality
No AC output, AC out1 only, AC out1&2
Main battery state of
charger
Bulk; Absorption; Float; Standby; Const. volt
0..16 V; 0..32 V; 0..64 V
Main battery current (minus
is discharging)
-25..50 °C, if not connected: ---
Selected shunt device for
the main battery
Main battery state of charge
Secondary battery charger
state
Bulk; Absorption; Float; Standby; Const. volt;
Error
Secondary battery voltage
Secondary battery current
* Models 12/3000-150 and 24/3500-100 only