What to do if the (3) light is red on my Mastervolt MASS COMBI PRO 12/3000-150?
If the (3) light is red on your Mastervolt Inverter, it means the inverted power exceeds 3500 W. To resolve this, check the connected load and disconnect some devices.
Why is the (9) light red on my Mastervolt MASS COMBI PRO 12/3000-150 Inverter?
If the (9) light is red on your Mastervolt Inverter, it indicates that the battery voltage is low. The solution is to stop inverting and start charging the battery.
What does it mean when (3) and (9) are blinking fast on Mastervolt MASS COMBI PRO 12/3000-150, and how do I fix it?
If the (3) and (9) lights are blinking fast on your Mastervolt Inverter, it means the number of inverter overload restart attempts has been exceeded. To fix this, reduce the output loads and then shut off and on the Mass Combi Pro.
What to do if the (2) light is blinking fast on my Mastervolt Inverter?
If the (2) light is blinking fast on your Mastervolt Inverter, it indicates that the mains input voltage or frequency is out of range. To resolve this, check the mains voltage and frequency, and refer to the generator input specifications.
What does it mean when (5) and (6) are blinking fast on Mastervolt MASS COMBI PRO 12/3000-150?
If the (5) and (6) lights are blinking fast on your Mastervolt Inverter, it indicates an installation error. Correct the installation, then shut off and on the Mass Combi Pro.
Why is the (1) light blinking fast on my Mastervolt MASS COMBI PRO 12/3000-150?
If the (1) light is blinking fast on your Mastervolt Inverter, it indicates that the generator input voltage or frequency is out of range. Check the generator voltage and frequency, and refer to the generator input specifications.
What does the (4) yellow light mean on my Mastervolt MASS COMBI PRO 12/3000-150 Inverter?
If the (4) light is yellow on your Mastervolt Inverter, it indicates that the Combi is too hot. It will restart when the alarm is over.
What does it mean if (9) is red and 7 and 8 are yellow on my Mastervolt MASS COMBI PRO 12/3000-150 Inverter?
If the (9) light is red, and the 7 and 8 lights are yellow on your Mastervolt Inverter, it means the battery voltage is too high. The Combi will restart when the alarm is over.
How to switch on Mastervolt Inverter?
To switch on the Mass Combi Pro, use the main switch.
What does (1) blinking slowly mean on Mastervolt MASS COMBI PRO 12/3000-150 Inverter?
If the (1) light is blinking slowly on your Mastervolt Inverter, wait until the inverter is ready synchronizing. After this, it will activate the generator input.
General| Brand | Mastervolt |
|---|---|
| Model | MASS COMBI PRO 12/3000-150 |
| Category | Inverter |
| Language | English |
To Next Page