EasyManuals Logo

Mastervolt Whisper 6 User Manual

Mastervolt Whisper 6
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
MAINTENANCE
22 July 2009 / WHISPER 6/8/11 / US / Copyright © 2009 Mastervolt
A smeer of oil has to be put on the seal of the filter before
fitting the filter. The filter should be fastened manually:
when the rubber touches the metal turn 3/4 further.
Figure 12
4.2.6 Readjustment of the V-belt
The alternator bracket allows for readjust of the V-belt.
Deflections should be 10 mm (refer to fig. 13)
Figure 13
4.3 REGULAR MAINTENANCE
CHECK DAILY:
Oil level (see fig. 14)
Take care the oil level is never
below the mark. Do not oil
when the level is still above
the mark
1 Minimum oil level
2 Maximum oil level
Fig. 14:
CHECK DAILY:
Level cooling liquid
Hoses for loose connections or deterioration.
Water inlet filter.
AFTER FIRST 50 HOURS:
Change oil and replace the oil filter.
Have the engine run until it is on temperature and
stop it. Drain oil by the sump pump into a suitable
retainer and fill up with fresh oil. Start the engine
again and have it run for 5 minutes. Stop the
engine again and pause for a few minutes to let
the oil gather in the crankcase. Check the level
again and add oil when necessary.
Check and tighten nuts, bolts, and unions, paying
particular attention to the fuel system.
Observe the exhaust at the normal full load. The
exhaust must be free from soot. Do not allow the
engine to run with a dirty exhaust without
investigating the cause as this may result in an
expensive breakdown.
Check air vent on a regular basis. When the air
vent it not working properly the engine can fill up
with water by siphoning. Water in the combustion
chamber causes serious damage to the engine.
Check and readjust V-belt.
Check the electrical connections
EVERY 150 HOURS:
Change oil.
Check the battery acid level (not applicable when
Mastervolt batteries are used).
Check battery terminals for corrosion
Check and readjust V-belt
Check impeller raw water pump (durability
depends on the purity of the sea water. In sandy
water and warm water wear will increase).
10 mm
1
2

Table of Contents

Other manuals for Mastervolt Whisper 6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mastervolt Whisper 6 and is the answer not in the manual?

Mastervolt Whisper 6 Specifications

General IconGeneral
BrandMastervolt
ModelWhisper 6
CategoryInverter
LanguageEnglish

Related product manuals