99
98
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET)
Once the cardio equipment has been installed and proper power and cable wiring is provided, The Television must be programmed to the club's
channels and settings.
AutoTuning - An auto scan will search for channel signals from the coax cable. It will tune in all channels that provide a signal.
1. Press ENTER, 1, 0, 0, 1, ENTER on the number keypad to enter Manager Mode.
2. Press TV on the display (Figure A).
3. Press SETUP on the display (Figure B). A TV will appear.
4. Press the - key on the number keypad and a Menu will appear on the TV (Figure C). note: Once the Menu is present on the screen, the
following buttons must be pressed quickly, or the Menu will minimize after 5 seconds of no key strokes.
5. Use the VOLUME UP or DOWN keys to move horizontally in the Menu and the CHANNEL UP and DOWN keys to move vertically.
6. Use the VOLUME UP or DOWN keys to scroll the cursor to Channel Mode of the Menu, then press the ENTER key to enter the Auto Tuning
of sub-menu (Figure D).
7. Press the ENTER key to activate the Auto Tuning Mode and the display will show Tune Type / Country. Use the VOLUME UP and DOWN
keys to select Tune Type (DTV, ATV, or DTV+ATV), then press ENTER key to confirm and store setting. NOTE: Choice the Tune Type with
DTV+ATV that’s recommended (Figure E).
8. Use the CHANNELL UP or DOWN keys to select a country, then press ENTER key to confirm and store setting (Figure F). .
FIGURE BFIGURE A
FIGURE FFIGURE E
FIGURE C
FIGURE D
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET) - CONTINUED
AutoTuning(continued):
9. The tuner also will start auto tuning (Figure G & H).
OptionMode-Option Mode will help to define a language setting. Use the following procedure to manually set up the OSD Language,
Audio Languages and Subtitle Language. Also you can do the Restore factory default for language default be recovered on this mode.
1. Press the – key on the number keypad to return to the main screen. Use the VOUME UP or DOWN keys to select OSD Language (Figure
A). Press the ENTER key to enter the OSD language setup. Use the CHANNEL UP or DOWN keys to select the different settings (Figure B).
After find the correct language, press ENTER to confirm and store setting.
2. Follow Steps 1 instruction to access Audio languages and Subtitle language setting (Figure C & D). Also you can do the Restore Factory
Default for language default be recovered. NOTE: Doing “Restore Factory Default”, it will require setting the Language / Country again.
FIGURE BFIGURE A
FIGURE HFIGURE G
FIGURE DFIGURE C
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
To Next Page
Loading...
Need help?
General
