Matrix C7XE-05

103
102
CHAPTER 11: SOFTWARE UPGRADE INSTRUCTIONS
11.2 SOFTWARE UPGRADE PROCEDURE FOR LCB
FIGURE AFIGURE A FIGURE BFIGURE B
NOTE:1.InorderupdateLCBfromconsole,TheUCBsoftwareversionshouldbeupgradedtoGUIL2.0(application),IO10.2
andOS3.27.2orabove.TheinstructionsbelowareLCB1softwareupgradedprocessforH/U/R/E/S,buttheprocedureisthesame
withClimbMill.PleasechoosethecorrectLCBsoftwareforClimbMillupgrade.
1) Copy the update manager and LCB firmware files to USB Flash Drive root folder. Two files as below (Figure A).
2) Plug the USB Flash Drive into 7xe console. Software will automatically update. Note: During upgrade process, the LCD screen will be show
upgrade information (Figure B&C).
3) After the software installation is complete, remove the USB and turn off the power. Note: Wait at least 30 sec. then reboot machine.
4) Enter Manager Mode (ENTER, 1, 0, 0, 1, ENTER). Press the "About" tab and select the "software version" to check the updated successfully
loaded.
FIGURE CFIGURE C
NOTES