19
• The swing guard hood (19) is pushed back
automatically by the workpiece.
• Do not use force!
Push forwards gently and evenly with the circular
saw.
• The waste piece should be on the right-hand
side of the circular saw so that the wide section
of the support bench supports its full area.
• If you are sawing down a line that has been
drawn, guide the circular saw along the
corresponding notch.
• Clamp small pieces of wood securely before
sawing them. Never hold them with your hand.
• Always follow the safety instructions. Wear
safety goggles.
• Do not use defective saw blades or blades that
are cracked or broken.
• Do not use any anges / ange nuts whose bore
hole is larger or smaller than those in the saw
blade.
• The saw blade must not be decelerated by hand
or by applying lateral pressure to the blade.
• The swing guard hood must not jam and must
return to its initial position after the operation
has been completed.
• Before you use the circular saw, check the
function of the swing guard hood with the mains
plug disconnected.
• Before you use the machine, ensure that the
safety equipment such as the swing guard hood,
anges and adjustment devices are in working
order and are correctly adjusted and secure.
• You can connect a suitable dust extraction
system to the sawdust extraction connector (14).
Ensure that the dust extractor line is safely and
• Refasten the locking lever for miter setting (7).
Check the handle is securely fastened.
5.3 Extraction of dust and chips (Figure 6)
• Connect a suitable vacuum cleaner (a) to the
provided chip extractor connector (14) of your
circular saw (vacuum cleaner not included). This
will provide excellent dust extraction on the
workpiece. The benets are that you will protect
both the equipment and your own health. Your
work area will also be cleaner and safer.
• Dust created when working may be dangerous.
Refer to the section entitled “Safety instructions”.
• Important! The vacuum cleaner you use for the
extraction work must be suitable for the
workpiece material.
• Check that all the parts are properly connected.
5.4 Parallel stop (Figure 7/8)
• The parallel stop (16) enables you to saw parallel
lines.
• Loosen the locking screw for the parallel stop (8)
on the saw foot (6).
• To assemble, slide the parallel stop (16) into the
guide (a) on the saw foot (6) (see Figure 7)
• Set the required spacing and then tighten the
locking screw (8) again.
• Using the parallel stop: Position the parallel stop
(16) at on the edge of the workpiece and start
the cut.
Important! Carry out a trial cut in a piece
of waste wood
6. Operation
6.1 Working with the hand-held circular saw
• Always hold the circular saw rmly.
To Next Page
