25 Matrix ETERNITY NE Quick Start
• Connect the Power Adapter into the power jack and plug it into a power outlet.
• Switch ON the power supply and observe the reset cycle.
LED Indication
• At Power ON, Power LED will turn ON (Continuous Green).
• System LED (STS) will display following error/events/status:
• Mobile Ports take about 3 minutes to get registered with the network.
You may now access the web-based programming tool, Jeeves, and configure ETERNITY NENX.
LED Status Color Color and Cadence
1 sec ON-1 sec OFF (Continuous) Green ETERNITY NENX started successfully.
5 sec ON-5 sec OFF (Continuous) Green
Software Mismatch (uboot checksum did not
match)
10 sec ON-10 sec OFF (Continuous) Green Flash Lock due to License
100 msec ON-100 msec OFF-100 msec ON-
100 msec OFF-100 msec ON-5000 msec
OFF (Continuous)
Green Recovery mode*
* If you get Recovery Mode LED Status , contact Matrix Technical Support Team.
To Next Page
Loading...
