Matrix ETERNITY NENX - Accessing ETERNITY NENX Jeeves Configuration; Connecting Computer to ETERNITY NENX for Jeeves Access

Matrix ETERNITY NE Quick Start 26
CHAPTER 4 Accessing Jeeves
ETERNITY NENX provides a Graphic User Interface (GUI), Jeeves, for configuration. The accessibility to the web-
based GUI is secured by a password.
To access Jeeves, you will need to connect a computer to ETERNITY NENX.
Connecting a Computer
You may connect a standalone computer to ETERNITY NENX or grab any computer connected in the same LAN
as ETERNITY NENX.
• Connect a standalone computer to ETERNITY NENX, when installing the system for the very first time.
You may connect it to a computer in the LAN at a later stage, once you have finished installation and
configuration of the system.
• You will be able to use the VoIP interface only if the system is connected to the LAN network.
.
To connect a standalone computer,
• Plug one end of the RJ45 cable into the Ethernet Port of ETERNITY NENX and the other end into the LAN
port of the computer.
• Make sure the IP Address of the computer and the Ethernet Port of ETERNITY NENX do not conflict and
both are in the same Subnet.
The default IP Address of the Ethernet Port is 192.168.1.101
The default Subnet Mask of the Ethernet Port is 255.255.255.0
• Change the Subnet of the computer, if necessary.
• Open the Internet Explorer 7 or later or Mozilla Firefox 3.5.1 or later on the computer.
• Enter the IP address of ETERNITY NENX in the address bar of the browser.
• You will be redirected to the HTTPS protocol for secure access.