25
Fig. 8
Fig. 9
Fig. 10
4) Fitting the upper handle
The upper handle must be ! xed to the extremities of the two upper rings with two m8 screws, on the inner
side of the ring. Access to the inner part of the rings is possible by removing the lids that shut the extremities
of the rings.
5) Fitting of the radio console
The radio console must be ! tted on the back of panel PD at the head end through the two cup nuts situated
beside the support stand. The electrical connection panel PD is done by joining the connectors them to the
corresponding ones on the inside of the panel. Access to the inside for checks and maintenance is possible by
lifting the through lid which is situated on the back of the console and ! xed by two screws.
! ssing point
screw to ! x
consolle cup
Holes for ! xing
pin of panel
Holes for transit
packing form panel
to support ring
The button for the led control is on the cover of the radio console.
By pushing the button the led test is started and they will be on for 60 sec.
ONLY FOR INFORMATION
www.isoitalia.us
To Next Page
Loading...