26
Fig. 11
Fig. 12
6) Positioning of the reactances boxes and electrical panel
Place the three reactance boxes and the electrical panel on the ! oor starting from the foot end with n° 3 box
then n° 2 and then n° 1 then place the electrical panel beside them. The boxes must be positioned as close as
possible to the foot end in order to leave space at the head end for the through passage of the connecting ca-
bles. The boxes are supported by wheels movement easier.
All the connections mut strictly follow the numbering of the connectors.
Reactance box n°1Reactance box n°2Reactances box n°3
Electric panel
7) Fitting of the cover panel and positioning of the extraction and ventilation boxes.
After having " tted all the panels it is necessary to " t the back and front cover panels. Having previously ensured
that the power supply lead comes out from the rear of the head end all the other internal leads which connect
the rest of the machine.
Then place as shown on the diagram at the back of the machine the hot air extractor turbine box (" xing it
with the supplied screws from the inner side) and the Plexiglas box with the Plexiglas ventilation turbine
making sure to connect all the electrical parts.
NB: Failure to carry out the electrical connections will seriously jeopardize the correct working of the
solarium
To the box for the extraction of hot air must be connected to the expulsion pipes supplied, their lenght must
not exceed three metres and they must be put down as straight as possible (at the most with a bend of 90°). If a
longer amount of extraction pipe is needed then it is necessary to " x a supplementary extractor with a suitable
! ow capacity.
Turbine for Plexiglas ventilation
Air extraction for lamps ventilation
ONLY FOR INFORMATION
www.isoitalia.us
To Next Page
Loading...