Matrix MW200 User Manual

10
Detergent
To fill the detergent compartment
• Push the latch to open the
compartment.
• Add the required amount of detergent.
The main detergent compartment “b”
(Fig. 2) has lines to allow for specific
amounts of detergent. These are marked at either 15cm
3
or 25cm
3
, to
be used depending on how dirty the dishes are.
If your dishes are in need of an intensive wash, then add 5cm
3
of
detergent into the prewash section of the compartment “a” (Fig. 2).
• Close the detergent compartment lid until the latch locks.
Please note: You should only use detergents designed specifically
for use in dishwashers.
If using dishwasher tablets, always use the detergent compartment,
do not put them in the main body of the dishwasher or in the cutlery
basket. The solubility of dishwasher tablets can vary depending
on the temperature and duration of the programme. As a result, it is
recommended that powder detergents should be used in the shorter
programmes to allow better performance.
The use of separate detergent, rinse aid and dishwasher salt is
recommended rather than combination tablets as separates achieve
better wash performance.
If you do use combination detergents, add salt and rinse aid to the
dishwasher and then adjust the water hardness setting and rinse aid
Fig. 2

Matrix MW200 Specifications

General

Door color	Gray
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Fully built-in
Baskets adjustable placement	Upper
Cycle time	- min
Noise level	52 dB
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	10 place settings
Number of washing programs	3
Connected load	1900 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.73 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	818 mm
Installation compartment height (max)	870 mm