Matrix MW200 User Manual

7
Using your appliance
“Power” button (1)
To switch the dishwasher on or off, press the “Power” button (1). When
you switch on the dishwasher the “End of Programme” light will illuminate.
“Programme Selection” button (2)
To select a programme, press the “Programme Selection” button (3). The
dishwasher will store in its memory the last programme used.
“Programme Indicator” lights (3)
These lights will illuminate to confirm which programme has been
selected. If there is a fault on the dishwasher, the fault code will show on
these lights (page 20).
“Salt” and “Rinse Aid” warning lights and “End of Programme” light (4)
When either the dishwasher salt or rinse aid begins to run out, a warning
light will illuminate to advise that it needs refilling.
When the programme is complete, the dishwasher will emit five beeps
and the “End of Programme” light will illuminate.
Fig. 1

Matrix MW200 Specifications

General

Door color	Gray
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Fully built-in
Baskets adjustable placement	Upper
Cycle time	- min
Noise level	52 dB
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	10 place settings
Number of washing programs	3
Connected load	1900 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.73 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	818 mm
Installation compartment height (max)	870 mm