Matrix MW200 User Manual

9
Cancelling a programme
It is possible to cancel a programme once is has started.
• First open the door slightly to reduce the risk of water spillage.
• Press and hold in the “Programme Selection” button until the “End of
Programme” indicator flashes.
• Close the door. The dishwasher will run a drain cycle which will take
approximately 30 seconds. Once this is complete, the dishwasher will
beep five times and the “End of Programme” light will switch on.
Switching the dishwasher off
• Once the dishwasher beeps five times and the “End of Programme”
light switches on, the dishwasher can be switched off by pressing the
“Power” button.
• If leaving the appliance off for a long time, turn off the water tap and
remove the plug from the power socket.
Please note: The dishwasher should automatically continue on the
programme it has started if the door is opened or in the event of a
power cut.

Matrix MW200 Specifications

General

Door color	Gray
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Fully built-in
Baskets adjustable placement	Upper
Cycle time	- min
Noise level	52 dB
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	10 place settings
Number of washing programs	3
Connected load	1900 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.73 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	818 mm
Installation compartment height (max)	870 mm