Matrix MW200 User Manual

8
Starting a programme
• Press the “Power” button (the “End of Programme” light will be switched
on).
• Press the “Programme Selection” button until the required programme is
shown on the indicator lights.
• Once a programme is selected, the “End of Programme” light will switch
off.
• When you close the dishwasher door, the programme will start
automatically.
• If possible, avoid opening the door once a programme has started.
Please note: The dishwasher stores the most recently used
programme in its memory. To change the programme, simply press
the “Programme Selection” button.
At the end of a programme
At the end of a programme, the dishwasher will beep five times, and the
“End of Programme” indicator light will switch on.
Changing a programme
It is possible to change the programme, if necessary, once the
programme has started.
• First open the door slightly to reduce the risk of water spillage.
• Press the “Programme Selection” button until the required programme is
shown on the display.
• Close the door. The dishwasher will begin the new programme from
the point at which the old programme stopped.

Matrix MW200 Specifications

General

Door color	Gray
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Fully built-in
Baskets adjustable placement	Upper
Cycle time	- min
Noise level	52 dB
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	10 place settings
Number of washing programs	3
Connected load	1900 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.73 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	818 mm
Installation compartment height (max)	870 mm