Matrix MW200 User Manual

13
well water, you are recommended to contact your local water board to
confirm the water hardness level and to use filter and water refinement
devices.
Please note: The water hardness is preset to level “3”.
To change the hardness setting
• Press and hold down the “Programme Selection” button.
• Press the “Power” button to switch on the dishwasher.
• Keep the “Programme Selection” button pressed until all “Programme
Indicator” lights flash.
• To adjust the level, press the “Programme Selection” button until the
required level is achieved. The “Programme” lights will illuminate as per
the table below.
• To store the selected water hardness level, press the “Power” button.
Water hardness level British hardness dE Indicator lights illuminated
1 0-6 P1
2 7-14 P2
3 15-21 P3
4 22-28 P1 & P3
5 29-42 P2 & P3
6 43-63 P1, P2 & P3

Matrix MW200 Specifications

General

Door color	Gray
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Fully built-in
Baskets adjustable placement	Upper
Cycle time	- min
Noise level	52 dB
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	10 place settings
Number of washing programs	3
Connected load	1900 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.73 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	818 mm
Installation compartment height (max)	870 mm