Matrix MW200 User Manual

3
Important
• Read the instructions prior to installation and use of the
appliance.
• Do not lean or climb on the open dishwasher door, to
prevent damage.
• Close the dishwasher door after use, to prevent accidents.
• Use only detergents, salt and rinse aid specifically
designed for dishwashers.
• Do not put solvents in the dishwasher detergent
compartment, to prevent risk of explosion.
• Only put dishwasher safe items into the dishwasher. If in
doubt, check with the manufacturer of the items.
• Take care when loading the dishwasher to observe the
recommendations for best loading practice, and also
to ensure that sharp objects such as knives are placed
blade down, to prevent accidents.
• Do not open the dishwasher door when a programme is
running. If it is necessary to do so, then open it only slightly
to allow the dishwasher to pause the programme and
prevent any water spilling out. Remember that the water
in the dishwasher can be very hot when the programme is
running.
• When the dishwasher is not in use, we recommend that
you turn off the water supply at the supply tap and
disconnect the mains supply.
• If you are leaving the dishwasher for an extended period
you should leave the door slightly open to prevent the
formation of unpleasant smells.
• The plastic housing on the water inlet pipe contains an

Matrix MW200 Specifications

General

Door color	Gray
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Fully built-in
Baskets adjustable placement	Upper
Cycle time	- min
Noise level	52 dB
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	10 place settings
Number of washing programs	3
Connected load	1900 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.73 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	818 mm
Installation compartment height (max)	870 mm