To Next Page

To Previous Page

ENGLISH

ADDITIONAL NOTES

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

• Consult the dealer or an experienced radio/TV technician for help. 

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. 

FCC RF Radiation Exposure Statement: 

1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should

be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.

Before proceeding, ﬁnd the serial numbers located on barcode stickers and enter them in the spaces provided below. Use the information below when calling for service.

FRAME SERIAL NUMBER (Located on front lower frame)CONSOLE SERIAL NUMBER (Located on back of the console)

SERIAL NUMBERS