7
ENGLISH
PROPER USAGE
MOUNTING THE CLIMBMILL
1. Stand directly behind the ClimbMill. Grasp either the upper or lower handle
bars and step onto the ClimbMill until you are within comfortable reach
of the console, emergency stop lever, and remote handlebar controls.
2. There are two emergency stop buttons the ClimbMill. An emergency
stop lever is located on the console mast below the display, and an
emergency stop button is located on the lower right side handlebar.
3. The CONTROL ZONE will bring the step surfaces to a complete stop upon
detecting an object. The AUTO STOP SENSOR will bring the step surfaces
to a complete stop upon detecting an object under the bottom step.
4. To determine proper workout position, stand on the steps within comfortable
reach of the console. Maintain a constant distance from the console and
remote handlebar controls. Keep your knees slightly bent at all times.
LEVELING THE EQUIPMENT
Locate a level, stable surface to position the equipment. The equipment has levelers
located below the bottom step. To access the levelers, remove the CONTROL ZONE.
CAUTION: There is an electrical plug located under the CONTROL ZONE and will
need to be unplugged before the cover can be completely removed. Use an Allen
wrench to level the unit. Once stable, replace parts as they were removed.
A carpenter’s level is recommended.
NOTE: There are only two levelers on the equipment.
WARNING!
Our equipment is heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.
BEFORE YOU BEGIN
CLIMBMILL SPM (STEPS PER MINUTE)
LEVEL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25
SPM 24 30 36 42 48 54 60 66 72 78 84 90 96 102 108 114 120 126 132 138 143 148 153 158 162
EMERGENCY STOP
LEVER
AUTO STOP SENSOR
CONTROL ZONE
To Next Page
Loading...
Need help?
General
