27
Once the device is running, the choke lever (10)
can be returned to the "ON" position.
CAUTION. The cutting device continues to still
rotate for a few seconds
after stopping the engine. Hold both
handles firmly up to the complete standstill
of the cutting device.
Now press the release button (4) and then the
throttle lever (2) until the device runs smoothly
and has reached full speed.
Start with warm engine
- Corresponds to the procedure as for the cold
engine. The choke lever always stays in the "ON"
position.
5.2 Stop and switch off
Release the throttle (2).
- Allow the engine to return to idle mode without
gas and let the devoice to run for 10 to 15
seconds.
- Set the operating switch (3) on the operating
handle to "O".
6. Working with the brush cutter /
grass trimmer
- Familiarize yourself with the operation and
control when the appliance is switched o the
rst time you work with a petrol brush cutter.
- The petrol brush cutter is designed in such a
way that it is controlled by the operator only on
the right side of the body.
- Always hold the petrol brush cutters by the
handles with both hands rmly.
- Hold the control handle with your right hand
and the handle of the handrail with your left
hand.
- Always make sure that the cutting tool
continues to rotate for a short time after the
throttle has been released.
- Always ensure proper engine idling so that the
cutting tool does not turn when the throttle is
depressed.
- Always work at high speed, through which you
will have the best cutting result.
- Control the device from left to right and back
with an evenly curved movement.
Then cut the next track.
Caution: Always return the device to its original
position before cutting the next length.
- If you hit against a stone or tree while working,
turn o the engine and disconnect the spark plug
10
ON
A18
A19
4
2
To Next Page
Loading...
