Matrix PETROL 4-IN-1 User Manual

33
8.2.2 Change of spark plug
Check the electrode gap of the spark plug (h) at least once
a year or if starting is dicult on a regular basis. The correct
distance between the starting ag and the ignition contact is
0.6-0.7 mm.
- Wait till the engine has cooled completely.
- Remove the 2 locking screws on the housing with the
screwdriver (23) and open the housing of the spark plug
assembly.
- Remove the spark plug cap (i) from the spark plug (h) and
unscrew the spark plug with the spark plug wrench (22)
supplied.
- In case of excessive wear of the electrode or in case of very
strong encrustation, the spark plug must be replaced with
one of the same type. Strong encrustation on the spark plug
may be due to: Too much oil in the
petrol mixture, bad oil quality, overaged
petrol blend or clogged air lter.
- Turn the spark plug (h) completely into the winding
manually. Avoid tilting the spark plug.
- Tighten the spark plug (h) with the spark plug wrench (29)
supplied.
- When using a torque wrench, the tightening torque is 12-15
Nm.
- Insert the spark plug connector (i) correctly on the ignition
plug.
- Attach the spark plug assembly housing to the device with
2 locking screws.
8.2.3 Wearing parts
Even when used as intended, some components
are subject to normal wear and tear.
These components must be replaced regularly
depending on the type and duration of use.
These parts include the cutting tool and the
retaining plate.
h
h
i
0.6-0.7 mm
A26

Matrix PETROL 4-IN-1 Specifications

General

Brand	Matrix
Model	PETROL 4-IN-1
Category	Lawn and Garden Equipment
Language	English