10
The appliance and cutting tools must be regularly
and properly inspected and maintained. Damage
must be repaired by a specialist workshop.
Use only accessories recommended by the
manufacturer.
Let your device repaired only by qualied
personnel and only with original spare parts.
This will ensure that the safety of the device is
maintained.
Make sure that the cutting tool is stationary,
when the engine is at idle mode.
Check this regularly and do not use the machine,
if you see a movement in idle mode. Take the
machine to a specialist workshop for checking
and repairing. The adjustment of the idle speed
should also be done only in a specialist workshop.
CAUTION: The cutting tool rotates for a few
seconds after switching o the machine.
Lay down the appliance only after the cutting
tool has come to a standstill and the engine has
been switched o.
Replace a damaged cutting tool with a new one
immediately.
Always use only the original thread.
Never use a metal wire instead of the nylon
thread.
The appliance and cutting tools must be regularly
and properly inspected and maintained. Damage
must be repaired by a specialist workshop.
Use only accessories recommended by the
manufacturer. The use of accessories, especially
cutting accessories and protective devices, which
are not recommended by the manufacturer, can
lead to serious injuries and property damage.
Let your device to be repaired only by qualied
personnel and only with original spare parts.
This will ensure that the safety of the device is
maintained.
Kickback – blowback
When working with metal cutting knives, it may
lead to a blowback of the whole device or to a
sudden forward movement, if solid objects (trees,
twigs, stones, or the like) are touched.
This blowback occurs without warning and
can lead to loss of control over the device and
endanger the user and bystanders. There is
special hazard looming in areas where visual
inspection is dicult and there is dense
vegetation.
So please maintain control in the event of a
blowback
• Always hold the device rmly with both hands
while working.
• Make sure that you are standing securely. Keep
your feet comfortably spread and always count
on a possible blowback.
• Do not overestimate yourself and maintain
balance at all times while working.
• Before you begin to cut, the cutting blade
should have reached full working speed.
Stones and rubble could be thrown up while
clearing vegetation and cause severe injuries.
Make sure that the protective hood is securely
mounted.
If rotating parts (cutting knives) are improperly
fastened, this can lead to serious accidents.
Before starting work, check the cutting blade for
tightness.
Other risks
Even if you operate this device properly, there
will still be other risks. The following risks may
occur in connection with the style and design
of this power tool:
1. Health risks, which resulted due to hand-arm
To Next Page
Loading...
