9
In the event of a blockage due to foreign material
(stone, grass collection), turn o the device and
remove it with a blunt object. Never remove
blocking foreign bodies with your ngers, as this
may result in serious injury.
Always keep the running device away from the
body.
Do not overload the machine or perform any
work for which it is not intended.
Make sure that the ventilation openings are
always free of dirt.
Keep the device out of the reach of children.
Store the device in a safe and dry place.
After impact or other damage, check the machine
for damage.
Especially when trimming lawn edges, gravel
borders and the like, please note particularly that
stones and soil can be ejected from the cutting
threads.
Never cross roads or paths when the device is
switched on.
Never cut hard objects such as stones, etc. to
prevent personal injury or damage to the device.
Never use the device without a protection guard.
Never stop the cutter with your hands. Always
wait until it stops by itself.
Guide the thread head as close to the ground as
possible.
Cut only grass that grows on the ground.
Grass in cracks or on stones may not be cut.
Always make sure that there are no objects or
similar things accumulate in the cord head in the
protective hood or in the engine.
Operate the device only with protection guard.
Always switch o the appliance from before you
turn it o.
Pay attention to the risk of injury in the area of
the cutting device, which serves to cut o the
thread.
Risk of blowback! There is always a risk of
blowback if the cutting blade touches branches
or other objects. The brush cutters will be
uncontrollable and can be pushed with great
force in the direction of the operator.
Do not use the device without exhaust and
properly installed exhaust protection.
Do not touch the exhaust. Danger of burns.
Do not use wire or the like in the spools of thread.
Never cut hard objects such as stones, etc. to
prevent personal injury or damage to the device.
Never use the device without a protection guard.
Always use only the original thread.
Never use a metal wire instead of the nylon
thread.
The petrol brush cutter is intended for trimming
grass or grass, for cutting scrub, shrubs, bushes
and young trees in the private sector, dependent
on the mounted cutting tool.
The device may not be used for other purposes.
The manufacturer does not assume any liability
in case of Improper use as well as changes to the
machine.
Please also pay attention to the safety
instructions, the instructions for installation and
operation, as well as the operating instructions
and the other generally applicable accident
prevention regulations.
To Next Page
Loading...
