Matrix SATATYA PARAM NVR Quick Start 14
Opening the Top Cover
• Always wear an electrostatic discharge preventive wrist strap or belt and use a grounding
mat.
• Make sure the power supply is disconnected. Unplug the power cable, if you have connected
it to SATATYA PARAM NVR.
• Release two screws on the back side and two screws on both left and right side.
• Make sure the thumb finger touches downward, and then push back the rear back cover.
• Release four screws on both left and right side.
• Release two screws on the top side.
• Place your hand on the front top cover and pull it out.
Installing the Hard Disk
SATATYA PARAM NVR series supports maximum eight Hard disks. The storage capacity of each
hard disk is upto 18 Terabytes. By default, no Hard disk is provided with the system. You can
install them as per your requirement.
You are recommended to install video surveillance SATA Hard disks of any standard brand.