Matrix simado gfx11 User Manual

Matrix SIMADO GFX11 Quick Start 9
Powering ON SIMADO GFX11/GFX11E
• Connect the Power Adapter into the Power Jack, and plug it into a power outlet.
Use only the Power Adapter included in the SIMADO GFX11/GFX11E package. Using an alternative
non-qualified power adapter may possibly damage the unit.
• Switch ON the power supply. Also, press the ON-OFF button
1
to switch on your SIMADO
GFX11E.
As soon as SIMADO GFX11E is powered on, the battery will also start charging. To know
more about Battery Back-up, refer the topic Battery Back-up during Power Failure in the
SIMADO GFX11/GFX11E System Manual.
At first power on, keep SIMADO GFX11E connected to the power supply for atleast 24 hours to
enable correct and complete battery charging.
• Observe the reset cycle.
LED Indication at Power ON
• LED labeled as BAT
2
will start blinking (RED) after few seconds of Power On. It indicates the
charging of the battery.
• LED labeled as PWR will glow green continuously.
• LED labeled as FXS and RDY will blink (RED) four times (500ms On, 500ms Off) and then
turns Off.
• LED labeled as NW will start blinking (RED) after few seconds of Power On. It indicates the
network availability.
• LED labeled as RDY will start blinking (RED) slowly (1 sec On—1 sec Off) till successful
network registration. After that, it will glow RED continuously.
1. ON-OFF button is available only in SIMADO GFX11E.
2. Battery (BAT) LED is available only in SIMADO GFX11E.

Matrix simado gfx11 Specifications

General

Brand	Matrix
Model	simado gfx11
Category	Gateway
Language	English