Matrix simado gfx11 User Manual

Matrix SIMADO GFX11 Quick Start 11
Configuring SIMADO GFX11/GFX11E
You can configure SIMADO GFX11/GFX11E by dialing command strings from the telephone
connected to the FXS Port of SIMADO GFX11/GFX11E. You can configure SIMADO GFX11/
GFX11E from two modes namely: System Engineer Mode and System Administrator Mode.
System Engineer (SE) Mode
In System Engineer (SE) mode, you have full access to the system and you can configure and use
all the features of the system.
The System Engineer mode is protected by a password referred to as SE password.
To configure SIMADO GFX11 from SE mode:
• Lift the receiver of the telephone instrument connected to SIMADO GFX11/GFX11E.
• To enter SE mode, dial #*-19-SE Password. The default SE Password is 1234.
• Dial the command string.
• To exit SE mode, dial 00-#*
• Replace the receiver of the telephone instrument.
While dialing command strings, you must dial the digits and characters in a continuous sequence.
For example, to enter SE Mode you must dial the command string as #*191234
System Administrator (SA) Mode
In System Administrator (SA) mode, you have limited access to the system.
You can configure and access only following features:
•SA Password Change
•Software Version-Revision Display
• Call Duration Display
• Call Divert
The System Administrator mode is also protected by a password referred to as SA password.
To configure SIMADO GFX11 from SA mode:
• Lift the receiver of the telephone instrument connected to SIMADO GFX11/GFX11E.

Matrix simado gfx11 Specifications

General

Brand	Matrix
Model	simado gfx11
Category	Gateway
Language	English