MATSONIC MS7192S - Load BIOS Defaults; Load Optimum Settings

Chapter 3
32
PNP OS Installed
Enable this item if you are using an O/S that
supports Plug and Play such as Windows 95 or
98.
Resources
Controlled By
This item lets you select for Automatic or
Manual configuration of devices. If you set it to
manual, new items appear. You can use these
items to reserve an interrupt request line (IRQ)
and a DMA channel for the device by setting
the value to Legacy ISA.
Reset
Configuration Data
Your system stores information on the
configuration of Plug and Play devices. If you
enable this item, the system will delete the
current data and create new data at the next
system start up.
Assign IRQ for
VGA
If this item is enabled, an IRQ will be assigned
to the PCI VGA graphics system.
Load BIOS Defaults
If you select this item and press Enter a dialog box appears. If you
press Y, and then Enter, the setup utility is loaded with a set of
BIOS default values. The BIOS default values are not very
demanding and they should allow your system to function with
most kinds of hardware and memory chips.
Load Optimum Settings
If you select this item and press Enter a dialog box appears. If you
press Y, and then Enter, the setup utility is loaded with a set of
setup default values. The setup default values are quite demanding
and your system might not function properly if you are using
slower memory chips or other kinds of low-performance
components.