1.07
General Information
TI008G0001
Installation and commissioning
“The installation and commissioning are only permitted to authorised staff.
During installation, handle the machine components as indicated in this manual; if lifting is necessary,
verify rst the correct xing of specic devices for lifting and use adequate slings and equipment.
The machine installation should be as free as possible from any material preventing or limiting its
view.
If there are any, remove xing brackets or eyebolt blocking devices, previously tted to allow the trans-
port.
Check that all the machine safety devices are correctly xed and there are no moving or loose parts.
Also check soundness of the control unit components.
Connect the machine pneumatic system to the air distribution system and carefully check that pressure
is set to the correct value.
Check consistency between the voltage set on power transformers and the voltage value of the electri-
cal supply.
Before connecting the machine electrical system, check that the mains isolator is blocked in the open
position.
Verify that accident preventing guards are correctly installed and in perfect state.
According to the different national law regulations, the Customer might be required to inform
the Certied Authorities of the installation and set up and/or to undergo a system check if the
machines are provided with tank (SPV) or pressure devices (PED).
Periodic inspections are also foreseen.
The machine safety is not guaranteed in case of removal, by-pass or tampering of the
safety devices on the machine.
To stop the machine during an emergency, press the emergency stop button.
☞
Operating the machine
Only authorised and duly trained staff or at least with a sufcient technical experience should operate
the machine. The staff in charge of operating the system should be aware that the knowledge and ap-
plication of safety regulations is in an integral part of their job.
Unskilled personnel should not access the operating area and the machine control panel when the
system is live.
Before starting the machine, carry out following operations:
• Carefully read the technical documentation;
• Get information about the operation and position of emergency stop devices on the machine;
• Know which protections and safety devices are tted on the machine, their position and operation.
It is forbidden to either disconnect or partially remove the protections and safety devices. The same
applies for danger signals located in particular areas of the machine. It is strictly forbidden to access
the working area and the control and power cabins during operation of the equipment (even partial) or
immediately after it is switched off.
Protections and safety devices should be kept in perfect state so as to allow right operation; in case of
failure they should be repaired or replaced.
The use of not authorised components and accessories for the protections and safety devices may lead
to malfunctioning and dangerous situations for the operating staff.
To Next Page
Loading...
Need help?
General
