2.01
General Information - Safety
TI008G0001
• Protection and segregation of the electrical/electronic driving equipment of the machine by metallic
box, to avoid accidental contacts with live equipment in case the metallic box is open; the electric box
is IP 54 protected; IP 20 is the protection degree of the internal devices against accidental contact.
• Suitable panels or protection to cover moving parts.
• Electrical devices to detect faults of the machine electrical supply and malfunction of motor electrical
devices.
To operate the machine under any operating condition, including maintenance, it is not
necessary that more than one person be present.
Using more than one person is superuous and, in any case, not allowed for safety
reasons.
The employer should instruct the staff on the risks of accidents, on safety devices and on the
general rules concerning prevention and protection, as established by the European Community
Directives and by the current legislation in the country where the machine is installed.
The operator should be aware of the location and operation of all controls and of all
the machine features.
The operator should also have read the entire manual.
Only skilled engineers should carry out maintenance jobs, after having duly prepared the
machine.
Any unauthorized tampering or replacement of one or more parts of the machine, or the
adoption of accessories that modify the use of the machine and the use of different ma-
terials than those recommended in this manual, may be a potential risk of accidents.
It is strictly forbidden for the machine to be operated by two persons contemporane-
ously, one inside the guards and one on the control panel.
WARNING !!!
Our machine IS NOT SUITABLE for use in areas with potentially explosive atmos-
phere.
098
WARNING !!!
For compressors equipped with INVERTER, before performing any maintenance job,
wait at least 5 minutes after you have disconnected the electricity supply.
098
!
098098901
During the design phase all hazardous areas have
been considered and, therefore, all necessary precau-
tions have been taken to avoid risks to people and
damage to the machine components.
To guarantee both health and safety of those ex-
posed, the machine is equipped with appropriate
safety devices:
• EMERGENCY button to stop the machine immedi-
ately
• Fixed protections. located in areas with exclusive
access for routine maintenance. They are xed by
devices that need special tools for their removal, or
they are locked with screws.
Dangers and residual risks
To Next Page
Loading...
Need help?
General
