Mattei BLADE 18 Series User Manual

BLADE
4-1
TI215G0010
!
The whole area for the machine handling,
including the space between the parking area
for transport means and the machine installing
area should be identied and inspected
beforehand, to identify any possible
“DANGEROUS AREAS”.
Be careful when handling, lifting and transporting the
machine, not to damage it and not to damage things or
cause injuries to persons.
For this purpose:
– Verify the total mass of the machine and use a
forlift truck or an adequate lifting means. Specic
pictrograms indicate the lifting points.
– The centre of gravity is near the coupling between
motor and compressor; before lifting, check (lift the
unit from the ground just slightly) that lifting points
are correct and there is not risk of overturning.
– When lifting, be careful not to damage the bearing
structure (base) of the machine and the soundproof
canopy.
During the transport, carefully x the machine to the
means used, by blocking it lengthways and sideways.
It is recommended to protect the machine from
atmospheric agents with suitable covering.
Unpack the machine by removing the guards and place
it on the oor by means of a forklift truck to remove the
pallet.
Trasportation and handling

Mattei BLADE 18 Series Specifications

General

Brand	Mattei
Model	BLADE 18 Series
Category	Air Compressor
Language	English