9
Calder Brothers Corp
V1.0
Serial Number Range:
848-S-56TCG9Y2*03848 to ________________
Page 9
Model: 1560 Paver
If engine does not start quickly, repeat the PRE-HEAT step
• Adjust engine RPM as needed for smooth idle.
CAUTION: Do not Pre-heat more than 5 seconds at a time, or Glow Plug failure will
occur.
CAUTION: Do not use any starting uid, or engine warranty will be VOID!!!!
2.0 DRIVING
The paver will move forward by pushing both levers forward and will move backwards by
pulling the levers back. Steering a course is accomplished by adjusting the speed of one
handle relative to the other. HINT - to make driving easy, push both handles forward
to desired speed, then use only one handle to ne-tune your direction.
3.0 STEERING TENSION
The steer handles can be adjusted for operator preference on tension, (or drag). In a
loose position the handles will spring return to neutral, this requires constant pressure
on the handles by the operator. Tension can be added to the point were the handles are
locked and cannot be moved. The ideal setting is somewhere in-between were the han-
dles have enough tension to stay in the position the operator chooses, but not so sti as to
produce fatigue.
To adjust tension: loosen or tighten the nut located at the center of the aluminum discs
were the handles are attached.
To Next Page
Loading...